Electronic Transformers Technical Committee (ETTC)

Standards Development:

 

Existing Standards

The ETTC always welcomes input to its standards development. The input for standard revisions can be presented at an ETTC meeting or by contacting the appropriate working group chairman for an existing standard. However only active ETTC members with an IEEE membership may participate in the balloting of an IEEE standard.

A list of the IEEE standards and their respective scopes, that are presently maintained by the ETTC, follows below. These standards may be purchased by contacting the IEEE standards office at phone: 1-800-678-IEEE or via the IEEE website.

• Standard 111 - IEEE Standard for Wide-Band (Greater Than 1 Decade) Transformers
  
  Standard 266 -1969 - IEEE Test Procedure for Evaluation of Insulation Systems for Electronics Power Transformers
  
  Standard 295 -1969 - IEEE Standard for Electronics Power Transformers Electronics
  
  Standard 388-1992 - IEEE Standard for Transformers And Inductors in Electronic Power Conversion Equipment
  
  Standard 389-1996 - IEEE Recommended Practice for Testing Electronic Transformers and Inductors
  
  Standard 390-1987 - IEEE Standard for Pulse Transformers
  
  Standard 393-1991 - IEEE Standard for Test Procedures for Magnetic Cores
  
  Standard 436-1991 - IEEE Guide for Making Corona (Partial Discharge) Measurements on Electronics Transformers
  
  Standard 449 -1990 - IEEE Standard for Ferroresonant Voltage Regulator