\documentclass[10pt,twocolumn]{ccece05}

%\special{papersize=8.5in,11in} %This works for both ps and pdf at HOME
% Change margins ---------------------------------------------------------
%\voffset 0.65in %Need this line if producing ps output
%\voffset -0.25in %Need this line if producing pdf output

\title{\bf  INSTRUCTIONS FOR AUTHORS \\
  FOR 8.5x11-INCH PROCEEDINGS MANUSCRIPTS}

\author{
\parbox[t]{2.2in}{
\centering \normalsize
First Author Name\\
\emph{Author Affiliation line 1,\\
Author Affiliation line 2  \\
Author Affiliation line 3} \\
e-mail: first{\tt @}usask.ca}
\parbox[t]{2.2in}{
\centering \normalsize
Second Author Name\\
\emph{Author Affiliation line 1,\\
Author Affiliation line 2  \\
Author Affiliation line 3} \\
e-mail: second{\tt @}usask.ca}
\parbox[t]{2.2in}{
\centering \normalsize
Third Author Name\\
\emph{Author Affiliation line 1,\\
Author Affiliation line 2  \\
Author Affiliation line 3} \\
e-mail: third{\tt @}usask.ca}
}

\begin{document}

\maketitle
\thispagestyle{empty}\pagestyle{empty}
%\footnotetext{\noindent\normalsize Proceedings of the 2005 IEEE
%Canadian Conference on Electrical \& Computer Engineering.\\
%0-7803-8886-0/05/\$20 \copyright\ 2005 IEEE}

\begin{abstract}
\indent The abstract is to be in fully-justified italicized text,
at the top of the left-hand column as it is here, below the
author information. Use the word "Abstract" as the title,
in 12-point Times, boldface type, centred relative to the
column, initially capitalized, with a blank line separating
it from the text of the abstract. The abstract is to be in 10-
point, single-spaced type, and may be up to 3 in. (7.62
cm) long. \\
\indent Leave one blank line after the abstract. Type
"Keywords" in 10-point Times, boldface type, initially
capitalized, flush left relative to the column, without any
number in front of it, followed by a colon (:) and your
keywords on the same line. The keywords should list up to
five important descriptors of the paper.
Leave two blank lines after the abstract, then begin
the main text. \\
\indent The body of the abstract should include: (i) motivation
and statement of novelty; (ii) description of the main
concepts; and (iii) summary of results. This abstract
should refer very closely to the abstract submitted for
review to this conference. \\
\end{abstract}

\begin{keywords}
Manuscript preparation; formatting of text.
\end{keywords}

\section{Introduction}
\indent These guidelines include complete descriptions of the
fonts, spacing, and related information for producing your
proceedings manuscripts. Please follow them and if you
have any questions, direct them to the production editor at
the CCECE05 Conference Secretariat.

\section{Formatting Your Paper}

\subsection{Languages of Paper}
\indent All manuscripts must be in either English or French.

\subsection{Maximum Length of Paper}
\indent The paper should not exceed four pages. If the paper
is longer, you will be required to pay \$50 for every
additional page.

\subsection{Page Size}
\indent All printed material, including text, illustrations, and
charts, must be kept within a print area of 6-7/8 inches (17.5
cm) wide by 8-7/8 inches (22.54 cm) high. Do not write or
print anything outside the print area.  All
text must be in a two-column format.
Columns are to be 3-1/4 inches (8.25 cm) wide, with
a 5/16 inch (0.8 cm) space between them. Text must be fully
justified.  Since the conference proceedings will be printed on the
8-1/2 inch wide by 11 inch high paper, A4 format will not
be accepted.

\subsection{Main Title}
The main title (on the first page) should begin 1-3/8
inches (3.49 cm) from the top edge of the page, centred, and
in Times 14-point, boldface type, fully capitalized. If the title occupies
multiple lines, use 1.5 line spacing.  Leave two blank lines after
the title.

\subsection{Author Name(s) and Affiliation(s)}
Author names and affiliations are to be centred beneath
the title, and entered in Times 12-point, non-boldface type.
Multiple authors may be shown in a two- or three-column
format, with their affiliations below their respective
names. Affiliations are centred below each author name,
italicized, not bold. Include e-mail addresses if possible.
Follow the author information by two blank lines before
main text.

\subsection{Second and Following Pages}
The second and following pages should begin 1.0
inch (2.54 cm) from the top edge. On all pages, the
bottom margin should be 1-1/8 inches (2.86 cm) from the
bottom edge of the page for 8.5 x 11-inch paper.

\subsection{Type Style and Fonts}
Wherever Times is specified, Times Roman, or New
Times Roman may be used. If neither is available on your
word processor, please use the font closest in appearance
to Times that you have access to. Bitmapped
fonts is not acceptable. True-Type 1 fonts are preferred, but TrueType
fonts may be used as long as they are embeddable and subsettable.

\subsection{Text Balancing on the Last Page}
If the last page of your paper is only partially filled,
arrange the columns so that they are evenly balanced if
possible, rather than having one long column.

\subsection{Page Numbering}
Do not put page numbers on your papers. CCECE05 will
add appropriate page numbers to accepted papers
when the conference proceedings are assembled.

\subsection{Paper Identification}
CCECE05 will include the following identifier
printed in Times 10-point plainface in the bottom margin of the first page \\

\noindent CCECE 2005 - CCGEI 2005, Saskatoon, May/mai 2005
0-7803-8886-0/05/\$20.00 \copyright\ 2005 IEEE

\section{Main Text}
Type your main text in 10-point Times, singlespaced.
Do not use double-spacing. All paragraphs should
be indented 1 pica (approximately 1/6- or 0.17-inch or
0.422 cm). Be sure your text is fully justified; i.e., flush
left and flush right. Please do not place any additional
blank lines between paragraphs. Figure and Table
captions should be in 10-point, initially capitalize only the first word of each
figure caption and table title. Figures and tables must be
numbered separately. For example: "Fig. 1. Database
contexts.", "Table 1. Input data.". Figure captions are to be
below the figures. Table titles are to be centred above the
tables.

\section{First-Order Headings}
As in this heading, the first-order headings should be
Times 12-point boldface, initially capitalized, centred, with
one blank line before, and one blank line after. Use a period
(".") after the heading number, not a colon. Do not use any
punctuation at the end of the headings.

\subsection{Second-Order Headings}
As in this heading, they should be Times 12-point
boldface, initially capitalized, flush left, with one blank line
before, and one after. Do not use any punctuation at the end
of the second-order headings.

\subsubsection{Third-order headings.}
Third-order headings, as in
this paragraph, are discouraged. However, if you must use
them, use 10-point Times, boldface, initially capitalized,
flush left, preceded by one blank line, followed by a period
and your text on the same line.

\subsection{Footnotes}
Use footnotes sparingly (or not at all!) and place them
at the bottom of the column on the page on which they are
referenced. Use Times 8-point type, single-spaced. To help
your readers, avoid using footnotes altogether and include
necessary peripheral observations in the text (within
parentheses, if you prefer, as in this sentence).

\section{Illustrations, Graphs, and Photographs}
All graphics should be centred. For the best result in pdf document,
the manuscript's graphics should have resolutions of 600dpi for monochrome, 300 dpi for
grayscale, and 300 dpi for color.  Graphics must be inserted/embedded in your document.
Do not link to a separate file.

\subsection{Placement and Resolution}
All graphics should be centred. Manuscript graphics should have a resolution of 600dpi
for monochrome images, and 300dpi for grayscale or colour images. Graphics must be
inserted/embedded in your document.  Do not link to a separate file.

\subsection{Graph, Figure  and Table Captions}
Position figures and tables at the tops and bottoms of columns.  Avoid placing them
in the middle of columns.  Large figures and tables may span across both columns.
Figure captions should be centered below the figures; table captions should be centered above.
Avoid placing figures and tables before their first mention in the text.

\section{Conclusions}
Close the paper with conclusions stemming from the
pertinent results and discussion.

\section*{Acknowledgments}
Type "Acknowledgements" 12-point Times, boldface
type, centred relative to the column, without the number
in front of it. Provide acknowledgements for the input of
other individuals, as well as to sources of funding, if
appropriate.

\section*{Note on References}

Type "References" 12-point Times, boldface type,
centred relative to the column, without the number in
front of it. At the end of your paper, list and number all
bibliographical references in 10- or 9-point Times, singlespaced,
left justified relative to the column. When
referenced in the text, enclose the citation number in
square brackets, for example [1]. Where appropriate,
include the name(s) of editors of referenced books.
Follow the referencing examples from the main IEEE
journal, the Proceedings of the IEEE.

\begin{thebibliography}{99}

\bibitem{Smith}
A.B. Smith, C.D. Jones, and E.F. Roberts, {\it "Article
title with leading capitalization, and the comma inside
the quotes," Journal} (in Italics), vol. 10, no. 3,
pp. 1-10, Month Year.

\bibitem{Jones} Jones, C.D., A.B. Smith, and E.F. Roberts, {\it Book Title}
(in Italics, capitalized, ended with a period). Location:
Publisher, Year.

\end{thebibliography}

\appendix{}
\section{FORMS}
\subsection{Instruction for Authors}
This document.
\subsection{Bio Sheet and AV Requirements}
On the conference web site.
\subsection{Copyright Form}
You must include your fully-completed, signed IEEE
copyright release form when you submit your paper. We
must have this form before your paper can be published in
the proceedings. The Copyright Form is available on the
Conference web site.
\subsection{Registration Form}
Available on the conference web site.

 

\end{document}

--
\thispagestyle{empty}


\title{INSTRUCTIONS FOR AUTHORS \\
\vspace*{3mm} FOR 8.5x11-INCH PROCEEDINGS MANUSCRIPTS}

\author{Author Name(s)}
{\textit{Author Affiliation(s)}\\
email Address(es)}

\author{Author Name(s)}
{\textit{Author Affiliation(s)}\\
email Address(es)}

